Warehouse top dust collector production process
2025-05-28 12:14:45
Warehouse top dust collector production process Warehouse top dust collector production process Mixing station warehouse top dust collector working in the mixing station knows how it is made (crest top dust collector)? Can be divided into the following points, I will explain for you, so that the user can further understand the warehouse top dust collector.
Production method explanation:
1. First, roll the outer casing (cylinder) of the top filter, and then weld it. After welding, spray it to prevent rust.
2. Connect the upper and lower sections of the cylinder and connect them with clamps. There is a sealing ring on the outside of the cylinder. Put the clamp on the sealing ring with screws and tighten the clamp with screws. Be sure to tighten to prevent ash from leaking inside the top of the roof.
3, using polyester fiber (non-woven fabric) as the main material to make the dust filter, must use the quality of the standard imported materials to extend the life of the filter.
4. Install the vibrating plate in the middle section of the cylinder. Note that the outer diameter of the vibrating plate must have a sealing ring. Install the vibrating plate and install the vibrating motor on the vibrating plate. In the 14 round holes of the vibrating plate, install the dust filter element and fix it.
5. Install the rain cap on the top of the top of the top of the top of the warehouse dust collector, fix it with screws, and choose the rain cap (round, square) according to customer requirements.
6. Finally, make a round hole in the middle cylinder, and turn the vibration motor "target=_blank> machine wire out, and install it on the online box.
The above is a brief introduction to the installation process of the mixing station warehouse top dust collector (the roof dust collector), basically these several processes. It is hoped that the unit or individual of the top of the mixing station can help to understand the top dust collector.
Http://news.chinawj.com.cn
Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn
Production method explanation:
1. First, roll the outer casing (cylinder) of the top filter, and then weld it. After welding, spray it to prevent rust.
2. Connect the upper and lower sections of the cylinder and connect them with clamps. There is a sealing ring on the outside of the cylinder. Put the clamp on the sealing ring with screws and tighten the clamp with screws. Be sure to tighten to prevent ash from leaking inside the top of the roof.
3, using polyester fiber (non-woven fabric) as the main material to make the dust filter, must use the quality of the standard imported materials to extend the life of the filter.
4. Install the vibrating plate in the middle section of the cylinder. Note that the outer diameter of the vibrating plate must have a sealing ring. Install the vibrating plate and install the vibrating motor on the vibrating plate. In the 14 round holes of the vibrating plate, install the dust filter element and fix it.
5. Install the rain cap on the top of the top of the top of the top of the warehouse dust collector, fix it with screws, and choose the rain cap (round, square) according to customer requirements.
6. Finally, make a round hole in the middle cylinder, and turn the vibration motor "target=_blank> machine wire out, and install it on the online box.
The above is a brief introduction to the installation process of the mixing station warehouse top dust collector (the roof dust collector), basically these several processes. It is hoped that the unit or individual of the top of the mixing station can help to understand the top dust collector.
Http://news.chinawj.com.cn
Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn
Solar Street Light&Flood Light
Ningbo Wason Lighting Technology Co.,Ltd , https://www.nbwasonled.com