Correct Usage and General Troubleshooting of Wagner Electrostatic Spray Gun
2023-07-31 10:11:23
Treatment method 1. When using the solvent, it should meet the local regulatory requirements.
2. It is not suitable to clean the spray gun electrostatic device;
3. Check the spray gun resistance daily;
4. No waste and rags in the spray area;
5. Keep the work area ventilated;
6. Pay attention to the air pressure should not be too high (0.4-0.55MPa), regular measurement of the resistance value of the gun is recommended.
7. Eliminate all sources of fire;
8. Qualified experience staff is preferred;
9. Pay attention to the paint resistivity.
General faults and treatment methods:
1 Pull the paint on the lever above the trigger: The rod seal is worn and the seal can be replaced. Electrostatic spray guns generally avoid premature wear.
2 Spray paint on the tip of the gun: The needle and nozzle are worn. Need to change the wear of the needle. The way to avoid premature wear of the electrostatic spray gun is to adjust the flow control knob to the maximum; connect the paint regulator and adjust it through the regulator. Paint flow, reducing the internal pressure of the spray gun and using high quality paint.
3 Atomization of the paint is defective or the fan size is asymmetric: Replace the air cap/nozzle or impurities in the gun. The disposal method of the Dongguan electrostatic spray gun is generally to disassemble the spray gun and clean the internal air line.
3D Wire Fence Introduction:
2. It is not suitable to clean the spray gun electrostatic device;
3. Check the spray gun resistance daily;
4. No waste and rags in the spray area;
5. Keep the work area ventilated;
6. Pay attention to the air pressure should not be too high (0.4-0.55MPa), regular measurement of the resistance value of the gun is recommended.
7. Eliminate all sources of fire;
8. Qualified experience staff is preferred;
9. Pay attention to the paint resistivity.
General faults and treatment methods:
1 Pull the paint on the lever above the trigger: The rod seal is worn and the seal can be replaced. Electrostatic spray guns generally avoid premature wear.
2 Spray paint on the tip of the gun: The needle and nozzle are worn. Need to change the wear of the needle. The way to avoid premature wear of the electrostatic spray gun is to adjust the flow control knob to the maximum; connect the paint regulator and adjust it through the regulator. Paint flow, reducing the internal pressure of the spray gun and using high quality paint.
3 Atomization of the paint is defective or the fan size is asymmetric: Replace the air cap/nozzle or impurities in the gun. The disposal method of the Dongguan electrostatic spray gun is generally to disassemble the spray gun and clean the internal air line.
3D Panel Fence
3D Wire Fence Introduction:
- 3D Wire Fence is also called
the Curved Wire Mesh fence. This is a new type of fencing, which is
mainly popular in developed countries such as the United States, Japan,
Korea, and so on. The 3d fence has the characteristics of beautiful
appearance, no limitation of terrain fluctuation and convenient
installation.
- 3D Wire Fence is wide used
for Garden, factory, road, highway, public buildings, parks, government
buildings, ball court, industry & commercial sector and so on.
3D Panel Fence,3D Mesh Fence,3D Wire Fence,3D Wire Mesh Fence
HeBei Bosen Metal Products Co.,Ltd , https://www.hbbosenfence.com