Selection of materials, construction and acceptance standards for floor tiles
Tile selection materials:
Floor tiles selection Facing tiles should be smooth, uniform color, neat edges, complete edges and corners, no damage, and have product certification.
Tile construction:
1) Before the construction of the floor tiles, the floor tiles should be soaked in water, which should be soaked in the next day, and dry to the surface without water stains before paving.
2) Before the construction of the floor tiles, a reference line should be displayed on the floor. 3) When the floor tiles are being constructed, the concrete floor should be moistened with water. Apply cement mortar (including 20% ​​of 107 glue) on the back of the floor tiles. Lay out on the basis of the reference line and work closely together. After the second time, the line should be pulled. Check the seam straightness and adjust it immediately. Check it after every paving. 4) Toilets, kitchens, balconies, floor tiles, floor tiles must be inclined to the floor drain, tilt control in 2% (3mm). 5) dry shop should be leveling on the floor in accordance with the level of bombing, set aside within two meters The block is then paved with a two-meter ruler to check whether it is smooth or not. The paved material is blended with 10:1 yellow sand and cement and leveled and compacted.
Acceptance of floor tiles:
1) The error within 2 meters shall not be greater than 2mm. The brick joints shall be neat and uniform in size. There shall be no hollowing or loosening. Acceptance shall be carried out with a ruler or ruler with a length of 2 meters. 2) In the acceptance process of the floor tiles, use a hammer to gently tap on the ground, without empty drums. 3) The slope of floor tiles with drainage requirements shall meet the requirements of drainage. Attention shall be paid to the joints with floor drains during inspection and acceptance.
Floor tiles Flooring Flooring Floor tiles Bathroom floor tiles
Bag Ties
Bag ties, also named as rod ties, are produced in a full range of black annealed, galvanzied and Plastic Coated Wire.
Specification:
SIZE(MM) WT(KG) STANDARD PACK PALLET QTY
110 5.9 5 148
125 6.4 5 128
150 7.1 4 112
175 7.8 3 96
200 8.63 3 80
250 10.5 2 64
300 11.7 2 48
350 13.12 2 48
Range:
above bag ties are made from 1.57mm diameter Wire. Other dia availabel upon request.
Finish: Black annealed, galvanized and plastic coated wire
Packing:
The standard pack is a bundle of 2000pcs, and the popular sizes of 110.125 and 150mm bag ties are also available in small packs of 200pcs. Other packing can be supplied as per customers requirement.
Plastic Coated Bag Ties Wire,Galvanized Bag Tie Wire,Plastic Coted Building Tie Wire,Rebar Tie Wire
Dingzhou Hongye Wire And Metal Products Co., Ltd. , http://www.chinawiremetals.com