Turning tooling design for thin-wall taper sleeve parts (2)
Figure 2 Schematic diagram of cutting
1. Process cylinder 2. Workpiece 3. Cutting knife
Although the process scheme can meet the process requirements of the parts, the material cost of the part blanks and the labor cost of the welding are increased, which is not economical. Based on the idea of ​​cost saving and product quality improvement, we have carefully designed the turning tooling of thin-walled taper parts. When turning a thin-walled taper-type part turning tooling tool, the part process is divided into the following two processes.
Car cone hole process
(1) Inside the cone hole tooling structure The tooling consists of two parts, a positioning sleeve 2 and a clamping nut 4, as shown in Fig. 3.
Previous page next page
Beauty Sponge,Face Wash Sponge,Cleansing Puff,Konjac Sponge
Liya Beauty Accessories Co., Ltd. , http://www.chinapowderpuff.com