What are the main points of the car park management system wiring construction
First, the signal line of the parking lot system control board cannot be laid in parallel with the AC power line, so as to avoid wearing it in a PVC pipe as much as possible. If it is limited by the environment, you must keep away from more than 50cm in parallel.
2. The AC power supply for the wiring of the parking lot system shall be routed separately. It shall not be in the same pipe as the signal line and the low-voltage DC power cable. Because the parking lot management toll booth will generally install air-conditioning, Guangzhou Nanze Electronic Technology Co., Ltd. recommends power supply. The size of the AC power cord should be adequately reserved.
3. When wiring the parking lot system, the distance between each equipment should be properly adjusted according to the site conditions. If there is no equipment in the system, the wire required for the equipment need not be laid, and the size and placement of the entrance and exit control machines, entrance gates, and entrance and exit cameras The same location.
Fourth, the parking lot wiring All external devices connected to the head can not be too long, so as to avoid exposure to short-circuit phenomenon, the parking system must be marked when the cable is marked, to facilitate the future installation, commissioning and maintenance.
5. When the entrance to the parking lot is at a slope, the control chassis should be installed on a relatively flat road surface, or a concrete pouring platform. Guangzhou Nanze recommends avoiding the occurrence of half ramps when the vehicle is swiped.
Sixth, car park system wiring should try to avoid wire joints. Unless joints are available, their joints must be crimped or welded and waterproofed. Wire connections and branches should not be subjected to mechanical forces.
7. Before cleaning the parking lot, brush the hole of the pipe. When you put the cable, you should wipe the grease or talcum powder. The cable that enters the nozzle should be kept straight, and measures such as moisture-proof and anti-corrosion should be taken.
Brandt 4' × 5' Shaker Screen
Replacement Hook Strip Soft Screens for Brandt 4' × 5' / B40 Shakers
Replacement Brandt 4' × 5' shaker screen is a kind of hook strip soft shaker screen. It is made of 304 stainless steel wire mesh cloth, designed with 2–4 layers composite bonded construction. Without steel backing plate, it offers maximum non-blanked area but increased fluid capacity. Bottom layer is made of coarse stainless steel wire mesh. It can supplies sieving action and serves as a support plate.
Technical Parameter
- Mesh Material: stainless steel 304/316/316 L.
- Frame Material: Q235 steel.
- Screen Type: XL, XR, MG.
- API RP 13C Designation: API 120 – API 325.
- Suitable Environment: water-based.
- Package: packed in paper carton, shipped by wooden case.
Adaptable Shale Shaker Model
SJ-Brandt 4' × 5' shaker screen are used as the substitute screen for
- Brandt 4' × 5' / B40 shale shaker
Competitive Advantage
- XL and XR mesh offer fine solids removal.
- Reduce requirement for mud dilution and treatment.
- Easy to install without any tools.
- Manufactured according to the API RP 13C (ISO 13501).
- Scientific & reasonable cost control system for competitive price.
- Adequate inventory in the shortest time to meet customers' demand.
Remarks:
Brandt 4' × 5', B40, are marks of Varco I/P, Inc.
ShengJia only produces the replacement screens but not original from Brandt.
Brandt 4'X5' Shaker Screen,Brandt 4'X5' Shale Shaker Screen,Brandt 4'X5' Oil Shale Shaker Screen ,Brandt Shakers
Anping Shengjia Hardware Mesh Co.,ltd , https://www.oilshakerscreen.com